Latex casting mould 15 cm - Pine cone

This latex mold is shaped like a pine cone can hold 1300 g of concrete or molding paste.

How to use: Make a support for your mold.

Cut into a strong cardboard a hole slightly smaller than the bead forming the base of the mold.

Use your mold as a measure to determine how much water you need.

Pour the water into a container and sprinkle with plaster until the liquid is completely absorbed.

Place your latex mold in the hole of the cardboard and put it upside down in a large glass that will serve as support.

Slowly roll the rubber several times to raise the air bubbles.

Wait for the plaster to dry completely to unmold.

Decorate your object.